|
1.
Install the main AP2006 Mk2 barn door arm kit according to the
fitting instructions supplied
2.
Check that the doors close properly with particular attention to
the bottom. (it is essential that the doors are not warped)
3.
Fix the bottom bolt assy to the door that is rebated to close last, with back
plate flush with the door edge and 25mm up from the floor. With
the doors held fully shut by the motor, the floor striker plate
can be positioned as shown in Fig. 2 below and secured with the
three No10 screws & masonry plugs supplied.
4.
Fit the cable stop to the AP2006 Mk2 actuator arm as above, then
attach the cable inner to the cable lug & secure with the M5
screw & penny washer supplied, pass the cable through the
cable stop and fit the outer cable.
5.
Fit the cable stop bracket to the door, pass the cable through it
and attach it to the floor bolt using the clamp supplied. Close
the doors with the motor, then
adjust the cable length so that the bottom latch bolt is engaged
into the floor striker plate by 10mm. |
